I have eth0 and eth1 bonded for a few years now, so I haven’t changed anything since the GUI has been changed over the last few software upgrades.
Note: array started
When I load the page it shows all the configuration in “interface eth0” and under “interface eth1” it says “interface not configured”. For simplicity and confusion wouldn’t it be better to collapse the entire eth1 section and have in say green writing something like interface bonded with eth0?
because it’s in orange writing as though there’s something wrong it may confuse people enough as it did for me to create a post.
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.