Unable to boot unRAID:
I updated from 6.9.2 to 6.10.0-rc1, the system boots to sysylinux select screen and upon selection proceeds to print device information, and then always prints the following (which prevents boot up):
//---
...
scsi 0:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6
sd 0:0:0:0: Attached scsi generic sg0 type 0
sd 0:0:0:0: [sda] 30031250 512-byte logical blocks: (15.4 GB/14.3 GiB)
Freeing unused kernel image (initmem) memory: 1636K
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: disabled. read cache: enabled, doesn't support DP0 or FVA
sda:
Write protecting the kernel read-only data: 16384k
Freeing unused kernel image (text/rodata gap) memory: 2036K
Freeing unused kernel image (rodata/data gap) memory: 452K
rodata_test: all tests were successful
Run /init as init process
INIT: version 2.99 booting
mount: proc mounted on /proc.
mount: sysfs mounted on /sys.
sd 0:0:0:0: [sda] Attached SCSI removable disk
mount: tmpfs mounted on /run.
waiting up to 30 sec for device with label UNRAID to come online ...
UNRAID boot device not found, press ENTER to reboot ...
//----
My feeling was that this was related to legacy/UEFI, but the system does this whether I set unraid/motherboard to boot via legacy or UEFI modes, and I had to revert to 6.9.2 (which boots ok).
motherboard: ASUS X99-E-10G WS
usb: SanDisk ultra fit (set in bios to come through as accessible as a drive at boot)
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.