I have 2 networks defined on the server:
- 1x Gb port on the mainboard
- 4x Gb ports on add-on card configured with link aggregation (802.3ad).
These ports are connected to Zyxel 1900-24E. The switch is configured
to handle the aggregated ports.
I make sure all is configured and working on the server, then reboot the server.
On next reboot, only the on-board port is working.
The other are down.
Issues:
- Non-main ports participating in LAG group in state DOWN have "Port Down" as text on the button.
Expected: the text should be "Port Up" as the port is already down.
- Clicking "Port Down" on a port in LAG group has no effect.
- Clicking "Port Up" on main port in LAG group brings only the main port UP.
This in combination with the above results in complete inability to change status of participating port.
At this point I have to disable the LAG so I can bring participating ports UP.
But, first I need to stop VM Manager.
Once VM manager is stopped and the LAG disabled, I can bring the ports up.
After couple of UP-DOWN-UP, I enable the LAG and then VM Manager.
I had the same setup with same hardware on old USB (last Unraid version there was 6.5.3).
I hadn't encountered this issue then.
It is VERY frustrating to go through this procedure, please help.
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.