Leaderboard

Popular Content

Showing content with the highest reputation on 07/29/18 in Posts

  1. Sure, just copy your profile to /mnt/user/appdata/MakeMKV/data
    1 point
  2. If the disk is missing then the file system check will be against the emulated disk. The results are what will be put onto disk 6 when you put it back in the array and then rebuild it.
    1 point
  3. Jul 28 10:34:20 Zeus kernel: XFS (md6): Corruption detected. Unmount and run xfs_repair Jul 28 10:34:20 Zeus kernel: XFS (md6): xfs_iread: validation failed for inode 100 Jul 28 10:34:20 Zeus kernel: XFS (md6): Corruption detected. Unmount and run xfs_repair Jul 28 10:34:20 Zeus kernel: XFS (md6): xfs_iread: validation failed for inode 100 You need to Check Disk Filesystem on disk 6 (BTW, this disk is still missing from the array and is being emulated) Also, turn off show PHP warnings in Tips & Tweaks (you enabled that). It's very annoying when you've got Preclear installed
    1 point
  4. /tmp is RAM, so if you have plex set to use /transcode then that should do it.
    1 point
  5. I've done this a few times now but recently my High Sierra refused to allow me to activate iMessage (only later I realised it was to do with the network card ordering mentioned below). I ended up just rebuilding the VM from scratch. The best guide I have found is here:- https://www.tonymacx86.com/threads/an-idiots-guide-to-imessage.196827/ If you use a fresh VM then you need not do all the clearing of the library folders, otherwise clean out the ones mentioned in the article. Having a proper serial number and board UUID is also required, the guide takes you through it. You need one that Apple says is invalid as it just means it hasn't been registered yet (a good thing). Ensure if using an existing VM you have signed into iCloud with that you remove it from your list of devices via Find my device on the iCloud site. One thing is *really* important and that is that the ethernet connection it set as eth0. If you only have the virtual network adapter then it should be fine but if you have a wifi card as well for handoff then sometimes it can get mixed up. Also remember that using UI mode in unRAID causes manual edits to disappear from the XML. I sometimes forget this and then waste a few hours before realising. If you follow the steps in that article though it should be fine...
    1 point
  6. 1 point
  7. Here's the unionfs plugin: https://raw.githubusercontent.com/Starbix/unRAID-plugins/master/plugins/unionfs.plg Oh and does it work for you? Join the plex discord if you want to, I can help there
    1 point
  8. Hey I wrote a plexdrive plugin. Here it is: https://raw.githubusercontent.com/Starbix/unRAID-plugins/master/plugins/plexdrive.plg I'm totally new to plugin writing, but I also have a unionfs plugin if anyone else is interested. Hopefully it works for you guys
    1 point