Fantomm3

Hi, I have installed powertop and have it auto-tune at every boot via go file, all my tunables report "good" but In not able to get passed C3, and even that is only possible with my array stopped, I have a 4790k and with array stopped currently its sat at 120w Any help would be much appreciated, my electricity bill is killer being in the UK tower-diagnostics-20230803-1135.zip

Thanks, I made sure everything C state related is enabled in bios, I see that the cpu goes down to 800mhz when idle. Im not sure how to check vclock in unraid? Also my board is asus (maximus gene vi) not sure the equivalent setting? Ill have a look for the spaceinvader quadro video, but I dont think it is using power, could be wrong.

I cannot seem to get my system to go past C3, its spec; M/B:ASUSTeK COMPUTER INC. MAXIMUS VI GENE Version Rev 1.xx - s/n: 130713231100205 BIOS:American Megatrends Inc. Version 1603. Dated: 08/15/2014 CPU:Intel® Core™ i7-4790K CPU @ 4.00GHz HVM:Enabled IOMMU:Enabled Cache:256 KiB, 1 MB, 8 MB Memory:16 GiB DDR3 (max. installable capacity 32 GiB) Network:bond0: fault-tolerance (active-backup), mtu 1500 Kernel:Linux 5.19.17-Unraid x86_64 OpenSSL:1.1.1s with a quadro p4000 and around 10 drives + nvme cache via pcie adapter Ive tried many suggestions on this thread, the powertop auto-tune runs and all tunables report as "good" I even swapped out my PCIE sata card for an ASM1166 card and no change, system uses 50w as a bare minimum with all drives spun down, and most times its around 130w, was hoping to do better than that, any suggestions?

did that and when i restarted the array everything is back, thank you so much!

Thanks I just tried this, it results in an extremely long result window with some of my file names seen but stating for example "in shortform directory 19158905110 references non-existent inode 4262355445" with the last few lines being: No modify flag set, skipping phase 5 Inode allocation btrees are too corrupted, skipping phases 6 and 7 Maximum metadata LSN (2:2244458) is ahead of log (2:2244140). Would format log to cycle 5. No modify flag set, skipping filesystem flush and exiting.

Hi, Im hoping someone can help. So recently I upgraded to a 6 port SATA PCIE card, after which I noticed one of my 10TB drives was disabled so I followed the instructions here: https://wiki.unraid.net/Manual/Storage_Management#Rebuilding_a_drive_onto_itself Following that it took 24 hours to sync and then the drive changed from a red cross to a green icon, however I still see "Unmountable: Wrong or no file system" next to the drive. Also now my Array is shrunk and I notice some files cannot be found I think the drive is mechanically fine, but it was full and now I think I have lost all the data?