Twofacedtrout

Cables changed and new diag attached. Disk 4 now appears to be ok????mediaserver-diagnostics-20240225-1149.zip

Morning, To give a bit of back story... I had a disk that was flagging up some errors, I took it out being cautious and replaced it with a spare drive. Array rebuilt fine with no issues. After the sync was complete, everything ran fine for over a day until I rebooted. Now I am faced with Disk 3 showing "Device is disabled, contents emulated" and "Unmountable: Wrong or no file system" Disk 4 showing "Unmountable: Wrong or no file system" Disk 7 showing "Unmountable: Wrong or no file system" Not sure what has happened? Does anyone have any ideas on what to do? Thanks for your help. mediaserver-diagnostics-20240224-1145.zip

My saviour once again. Thank you, JorgeB. I really appreciate you taking the time to help.

Hi all, Old SSD cache drives where slowly dying so I replaced with shiney new ones. Pulled them out, plugged the new ones in. Added them to the cache pool and restored appdata backup using the community app. Now Cache pool is showing a red x against both drives and it says "Device is disabled, contents emulated". Not sure where to go from here? Please help. mediaserver-diagnostics-20240103-1544.zip

Hi JorgeB, Just wanted to say a quick thank you. Server has been up and running for 8 hours with no issues where as before it would crash within an hour. Fingers crossed it stays like this. Appreciate everyone's help.

Thanks for the speedy reply trurl Diag attached mediaserver-diagnostics-20230104-2033.zip

Hi all, Looking for some guidance, I'm a unraid noob so please be gentle... My server keeps crashing/power cycling and I cannot figure out why, sometimes it crashes and is completely unresponsive but Unraid login still shows, other times it just dies and starts the boot up process again from bios. Started by doing this very randomly, has slowly worked its way up to crashing every hour. Things I have tried... PSU swap, Upgrade to Unraid to 6.11 from 6.9, CPU swap, Flash drive swap, Mem test, removed 10gb nic and run onboard... I'm sure there is more but not that I can think of right now. If anyone has any suggestions my ears are open. Now in my ultimate wisdom of trying to repair, I broke a sata connector to one of my drives and now the array does not start... I have the diagnostics before I fixed a cache drive issue 27/12/22 but now I'm kind of stuck, I have another drive to replace my stooopid mistake but if I start the rebuild I can almost guarantee the crash and I'm sure its not going to do the array any good. Back to the diagnostics... what file should I be looking at to find the errors? Would appreciate any help or suggestions you have. Thanks Craig