heoquoay

I'm upgrading my 2 parity, and use my old parity for drive. This is what I'm going to do plesse can you check if it correct. 1. Unbalance 2 smaller drive and move all the files to other drive. 2. Take pictures of drive position. 3. Remove 2 smaller drive. 4. Add 2 new parity drive. 5. New config 6. Set 2 old parity to the array, and set 2 new drive as parity. 7. Clear the old parity drive? 8. Start the array.

Thank you. I was trying to shorten the time since two 18tb will take forever.

Just ordered 2 bigger hard drive and plan to make it my new parity. Can i just 1) remove the 2 old parity drive 2) insert new one (pre-clear) 3) run parity? 4) use 2 old parity drive as data drive.

It been slow lately and I don't know why. I tried to get in unraid, but 50% of the time it have problem loading page.

I have no idea. But I found out that my cache have smart error. When the whole thing slower than before is it also the flash drive problem?

I just replace two smaller disk for bigger storage. After a weeks of pre-clear and re-build everything seem normal. When I tried to transfer files from my computer to Unraid it getting error and stop mid way. I checked Unraid during the stop and all the disk become blank (sometime) and sometimes it disconnect from server for a few second. My cache also have 900gb free space also. Please help. onepiece-diagnostics-20240218-2140.zip

Unable to find image 'lscr.io/linuxserver/jellyfin:latest' locally docker: Error response from daemon: Get "https://lscr.io/v2/": dial tcp: lookup lscr.io on 192.168.0.1:53: no such host. See 'docker run --help'. The command failed. Also change my IP to 192.168.69.199 which is my server ip. Please help

Transfer from my computer to unraid server. diagnostics-20230331-1924.zip

My transfer speed only 50mbps. Is there a way to improve and make it faster for upload and download between device at home?

It still 1000 mbps after turn off bonding

Is that in unraid setting? Where do I check for that?

I kinda figure it out from Interface eth0. but my new network speed is still the same as my old one 1000 Mbps, full duplex, mtu 1500. The wire is flat cat 7 connect direct to the router

Yeah I put the ethenet back to the main old port because it doesn't run when I use the new one. I'll check the bios tonight.

Just got home. Here is the diagnostics diagnostics-20230228-1836.zip

I have a supermicro server, and I added a new 10gbe NIC card to upgrade the speed. Do I need to configure anything in the bios or it usually work right away? Cause mine doesn't connect.