BodoTheWaterGuy

I swapped out the motherboard, processor and ram this morning. Booted fine. I can ping the servers, but cannot access the web GUI. I hooked up the server to a monitor and keyboard. No web access there either. Where do I start troubleshooting this? Thanks in advance

Howdy gang I've run into a problem that when I'm updating a docker install that it will fail due to my internet timing out. This wouldn't normally be a problem, just restart it. The issue I have is that it can take 5-10 attempts to complete and it's eating up my data cap. Downloading the same parts over and over again. Is there a way to make the docker system cache the parts locally?

Will check that when I get home. Thanks. Maybe. I caught it chugging away early this morning (yea 5 am alarms...) and it was working on 'deep analysis'. This isn't something I need PLEX to do. So, I turned off that option. When it was doing that, PLEX only had 300MB of memory tied up.

Working on that. Thanks

I don't have a problem using PLEX. It's been rock solid for the last week. IF I remember to turn it off before I head to bed. The internet is left on all night. If I don't, unraid is locked up as I described in the OP.

Understood. I'll upgrade to a real key once I establish that it will work as I need.

Yup, already did that!

I live out in the boonies. Just cellular data. So, when I'm home I have enough to do the stuff I want, like installing plugins and dockers.

No token. I don't have a real internet connection and I'm not planning on using the linked features of PLEX. regarding RAM: The server isn't doing anything else. Just NAS and PLEX. 4 GB or so of RAM should be plenty. Shouldn't it?

I guess I could, but if it's a hardware issue I'd rather just get something like this: https://www.newegg.com/hp-z-series-z420-business-desktops-workstations/p/1VK-001E-09AB7?Item=9SIAC0F8X67635 Went to startup the docker and it's gone. 'orphaned' it says. Going to take another stab at it and reinstall the docker and see what happens.

Here is the diagnostic zip. The raid is parity checking. When it's done I'll post the docker run commands. Thanks for the assist! tower-diagnostics-20200917-1014.zip

Howdy gang This is a new installation with 6.8.3. 2x2TB drives with one as parity. No Cache. It will run great as a plain NAS, but when I added PLEX docker it becomes unresponsive sometime overnight and when I wake up in the morning I can't login through the web interface. It's dropped off of the client IP table of the router and I can't ping it. Since it started doing it after installing the PLEX docker, if I turn the docker off at night the server will stay up for days. But, if I forget, it's dead in the morning. I tried the other PLEX dockers and it's the same thing. Any ideas? I can't get a log for obvious reasons :(