Doowle

Hello, starting today I get this message. Starting server Unsupported Java detected (66.0). Only up to Java 21 is supported. Just after updating to Unraid 6.12.9 I have another docker running minecraft and that one is fine, just one of them Any guidance available? J

Maybe It's a sequence or not TailScale, I may keep adding them for a bit. J

TailScale Plugin is back on and everything works so not sure that was my issue...

Funny, I had that one on as well... I'll put it back on and see what happens.

Thanks, I got bored and removed a ton and it's working now Putting them back, one by one. Do I need to tell anyone, once I've identifed the PlugIn? J

Yeah works that way, so it's a plugin then! Any way to identify which, or do I have to remove one at a time until it works? Thanks J

Hi, Recently my GUI stops responding then I start the array, up to that point it operates fine. If I disable VM's, no change, disable Dockers and the GUI is fine. However all dockers are operating normally. Diagnostics attached. Thanks Jonathan unhump-diagnostics-20231015-1237.zip

FWIW, my mad and dumb approach seemed to work. thank you for putting me on the right track. J

Not my best decision... Hard Powering now.

I did a stupid / bad thing. I just removed the system and domain folders in /mnt/user, thinking they didn't need to be there (there was a docker.img) there. Now it won't shut the array down! Sep 11 19:39:47 unhump root: rmdir: failed to remove '/mnt/user': Device or resource busy Sep 11 19:39:47 unhump emhttpd: shcmd (3085): exit status: 1 Sep 11 19:39:47 unhump emhttpd: shcmd (3087): /usr/local/sbin/update_cron Sep 11 19:39:47 unhump emhttpd: Retry unmounting user share(s)... Sep 11 19:39:52 unhump emhttpd: shcmd (3088): /usr/sbin/zfs unmount -a Sep 11 19:39:52 unhump emhttpd: shcmd (3089): umount /mnt/user Sep 11 19:39:52 unhump root: umount: /mnt/user: target is busy. Sep 11 19:39:52 unhump emhttpd: shcmd (3089): exit status: 32 Sep 11 19:39:52 unhump emhttpd: shcmd (3090): rmdir /mnt/user Been doing that for a while, I'm nipping out. If it's not stopped by the time I am back, what to do.. D

No custom scripts. If one exists in the array, would that stop it moving to the array?

I've done some research on this but I can't see anything to help me. Each time my array restarts I loose all my dockers, if I add them back they work fine with persistant data / config. I'm sure this is me, something I've done, I just can't see what. Thanks you in advance. Doowle unhump-diagnostics-20230911-1837.zip

Hi, Sorry I've been quiet - started a new job and had some other issues with Unraid that I needed to focus on. One of my drives got corrupted, i suspect the kernal panics may have caused an issue here - dunno. Syslog server wasn't setup properly so I've done it again and this time it's working. J

Sorry assumed that was in the diag files, my location is set to custom so I need to fix that and way again. My bad... J

Hi, Happened again, I have syslog server enabled and I'm running 6.11.1. TIA. J unhump-diagnostics-20221013-1018.zip