ahuque

I have been running unRAID on Pro Key since 2013 and previously on Basic Key even earlier. Recently due to limitation in expansion of the server, I upgraded my server hardware with the following Gigabyte GA-H110M-S2PV Intel® Core™ i3-6100 Processor 16GB G.Skill Ripjaws V DDR4-2400 (F4-2400C15D-16GVR) Supermicro AOC-SAS2LP-MV8 Cooler Master G550M PSU While building the system, as usual I tried out the system using Windows 10 USB Installer. After completing the build and plugging in the unRAID key the system does not Boot, it just posts and then goes into BIOS setup, please note that I am running the F3b beta BIOS because the original F2 BIOS does to provide the non UEFI boot selection. Need help in solving this, the family is up in arms due to the server being down for nearly two weeks.

Thanks for the feedback. I was about to buy it instead of the aoc-sas2lp-mv8 due to price. The supermicro card would cost be nearly double here in Bangladesh. So back to the drawing board, see what else I can come up with...

Hello all, this is my first post on forum, I have been running unRAID with 6 drives since 2012, But now I need to expand the drive capacity. So I need help with confirming if the LSI MegaRAID® SAS 9267-8i RAID Controller is supported by unRAID v5. And if so what do I need to do to install it. Any help highly appriciated. Thanks and regards.