i issued both commands EPC disable and the lowcurrentspinup. on my ST8000VN004 rebooted, but after a spin down event i got errors again a few days later.
If there another setting that needs to be disabled, i have forced the drive to stay spun up for the time being.
But i do operate a system with 3xLSI 9211-8i Controllers. Not had any issues with my other disks.
I do have 2xST8000VN004 additional drives but they are Parity Drives so never spin down.
Any suggestions?
I had the same issue after following the directions in this thread and rebooting my Unraid server. However, I found after a full power down and cold boot of my server, the issue appears to be resolved. I'm thinking my HDDs didn't actually apply the firmware changes until the system was fully powered off & back on. I haven't had an error in 2 months, where previously they'd occur within a couple of days.
6.9.x, LSI Controllers & Ironwolf Disks Disabling - Summary & Fix
in General
Posted
I had the same issue after following the directions in this thread and rebooting my Unraid server. However, I found after a full power down and cold boot of my server, the issue appears to be resolved. I'm thinking my HDDs didn't actually apply the firmware changes until the system was fully powered off & back on. I haven't had an error in 2 months, where previously they'd occur within a couple of days.