sleeper404
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
Gallery
Bug Reports
Documentation
Landing
Posts posted by sleeper404
-
-
I must have skimmed past that one, guess that memory is on the way out. Acknowledging via the smart warning didn't work but I'll clear the error counts and see if it reports a as pass afterwards.
-
I'm a bit lost on troubleshooting why the array is giving me a failure status. There were some disk read errors during the last parity check and 2 sectors were reallocated, but smart extended tests seem to pass on that drive and nothing else is obviously amiss from what I can tell. Diagnostics attached. TIA.
-
Just to update and close the topic, the card does work out of the box with the bnx2x driver and the faulty fan was the culprit! Thank you JorgeB for nailing that one right on the head.
-
I had to use a small mirror and a flashlight, but the fan has failed so that would make sense. Once the replacement arrives I'll swap it out and see what happens.
-
1
-
-
Heya, I've got a few spare 10G NICs I've been using (esx 6.7/7.0 support) for my servers and I'm attempting to get them to work in one of my unraid boxes. I can see the adapter in lspci and see that the kernel module is loaded, but nothing shows up under ifconfig or in the GUI to configure them. I've went in an deleted the previous network configuration to get a fresh start, but nothing seems to be getting me anywhere.
lcpci entries:
03:00.0 Ethernet controller: Broadcom Inc. and subsidiaries NetXtreme II BCM57810 10 Gigabit Ethernet (rev ff)
03:00.1 Ethernet controller: Broadcom Inc. and subsidiaries NetXtreme II BCM57810 10 Gigabit Ethernet (rev ff)
lsmod entries:
bnx2x 647168 0
mdio 16384 1 bnx2x
Thanks in advance!dstore-diagnostics-20210110-1428.zip
[Solved] Array Health Status FAIL - reacllocated sectors and read errors.
in General Support
Posted
Rebooting was required to clear the read errors and return the array back to a passing status. I've reseated the memory module and will continue to monitor the logs for that. Feel free to mark this one solved and thank you for the assist trurl!