VizeL

As a note, after restarting(?) it now works. No settings were changed

Hmm, thanks. Is there anyway to verify from the application that its the right path? I can't seem to find the path to specify for plexpy logs, other than whats specified in the docker. My plex logs are being read properly.

It shows me when a user is watching, but doesn't seem to store any of the data about what/when they watched etc. I'm getting this in logs: 2015-09-24 18:51:51 WARNING Unable to retrieve data. Any ideas?

Yup, my apologies. I should have specified in my first post. I thought I had written it down, but apparently I rewrote my post multiple times before I finally submitted it. I'll be able to post logs when I get home. I stripped the drive out of the external case and put it into one of the drive bays (norco ss-500). When I mounted it to read the data off (modprobe hsfplus) it was copying at about 30 MB/s, and slowed to about ~5MB/s before I stopped it. I'm inclined to think either a) the drive is dying or b) I may have some bad wiring issues. I wrongly assumed it was something else since I had a drive that was reading at a similar pace until i reformatted it but I didn't isolate all variables (I plugged it back in in a different bay). Thanks for your insight edit: I should be able to figure it out from here. Thanks!

Ah, thanks for the clarification. If thats the case, if the drive is not empty, would that slow it down? I didn't specify last time -- but it is not connected through USB Thanks for your help.

I'm attempting to run the preclear script on a drive formated as HFS+. It seems to be running at ~5MB/s, meaning it'd take well over a day to simply pre-read it. Is this typical? And if so, is there any way to format the drive from my unraid box? A bit unusual...but it also seems like my unRAID box is the only one that can read the drive...it doesn't show up when attached through SATA->USB to any of my other machines. (I did not directly connect through SATA -- it used to be in an external case.)