RWayneRoss

I do. It's a bit older than this setup, which might be good in this case. I'll put it together and give it a try. It'll take a day or more as I'll be tied up most of today with other duties.

Thanks @JorgeB. From what I've seen in the logs it always seems to be a GPF. If the memory has tested good, what else might cause those? I do have (2) LSI 9207-8i controllers, could it be a driver problem with those? I'm pretty sure I have some other hardware RAID cards that can be set to JBOD, perhaps I should try those next? Edit: I could also connect a few drives to the SATA ports on the motherboard and try to make a parity set.

I downloaded the latest version at memtest86.com and ran the full test... 4 passes and zero errors.

Version 6.9.2 did not help, in fact, made it worse. It ran for 18 minutes and I got: Aug 27 08:24:31 Home-Server kernel: traps: emhttpd[2500] general protection fault ip:14ab5d246554 sp:14ab5cb85be8 error:0 in libc-2.30.so[14ab5d1e1000+16b000] At this point I think it's a hardware incommutability.

Just downgraded to 6.9.2. I'll post results when I have some.

Yes, I just checked... it's a Corsair HX1050, 1,050 Watts.

I'm still on 6.11.0-rc4 and now I'm getting 100% CPU pegging on 2 of the 8 cores.

I ran it overnight a couple of days ago. It ran 4 full passes on 32Gb with 0 errors.

Here they are. JorgeB suggested I try 6.9, I'll try that shortly as well. home-server-diagnostics-20220827-0645.zip

Sorry, I'm new to unRAID, never thought of that. Here they are... home-server-diagnostics-20220826-1525.zip

No success. After the upgrade to v6.11.0-rc4 the parity creation made it to 10.1% before dying again. Syslog attached, look like a GPF near line 1365. home-server-syslog-20220826-1708.zip

Thank you @JorgeB, that has certainly helped. I've made it up to 3.5% so far. If it completes I'll mark your reply as the solution. It'll be wonderful to have a working server after trying to get it working for so long!

I just built my first Unraid server and am having a hard time tracking down the problem. I created a new array (six 14Tb drives) and have a 14Tb parity disk. The sync starts and within 4-5 minutes it has gone from 0.1% to 1.5% and it just stop progressing. Unraid shows it's still running but the only thing that changes is the estimated completion time, it has gone from 15 hours to 533 days. I've done a full memory check (32Gb), letting it run overnight and had 4 full passes with no errors. Everything is brand new, even the drives. Any help would be appreciated, here's the syslog, it seems to start having problems at about line 2773. syslog.zip