Sylwester

Hi @JorgeB If I remember correctly I had USB NIC connected with drivers installed (it is working but is not stable and crashes system randomly). Then I removed driver. Reboot. No access to server. Turn off server. That should be in prevoius syslog. Then I changed USB port. Turn on server. No access. Disconnect network cable from USB Adapter and connect to internal NIC. That should be visible in current syslog. zion-diagnostics-20240827-1100.zip

Server is build on my old micro itx motherboard with only 1 pci slot which is taken by hdd controller. I can only use USB model to upgrade network speed.

Without the realtek driver I lost completely connection. NIC is not working without it. Switch to onboard NIC helped I am online again. Crashes are gone as well but I am back to 1Gbps NIC.

I will try first with onboard NIC

Hi. I have attached the file. I noticed when Docker Containers are disabled system is not crashing. I was turning dockers on one by one and when I started Deluge, after few minutes system crashed. Maybe that has any connection with USB network card (Bus 004 Device 002 Port 4-1 ID 0bda:8156 Realtek Semiconductor Corp. USB 10/100/1G/2.5G LAN). I did upgrade from 6.12.6. I have plugin RTL8156(B) RTL8157 USB Drivers installed. zion-diagnostics-20240723-2322.zip

Hi, After upgrade to version 6.12.11 my unraid crashes all the time. Running time is random but usually after few minutes crashes and I need to hard shutdown. I do not have clue how to fix it. I even do not know where to start and how to troubleshoot. Can someone help please?

Hi, My on board network card doesn't support wake on lan on unraid so I bought USB Network Adapter 2.5Gbp (no pci slots available on motherboard) and I still cant wake up my machine. In bios I have enabled resume by PCI-E devices. Do I need to enable resume by USB as well? If I turn off Unraid the leds on adapter are off. There must be no power. If I use this above command "echo -n mem > /sys/power/state" leds are on but I cant wake up machine any way.

Hi, I am new here and I do not have experience with Linux at all. I build my NAS using my old Windows 10 PC and I noticed under Unraid WOL is not working. Under Windows 10 WOL was working fine. I did research and I found this NIC has a bug and WOL is disabled. Is any way to enable WOL support? Settings for eth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: Symmetric Receive-only Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: 1000Mb/s Duplex: Full Auto-negotiation: on Port: Twisted Pair PHYAD: 0 Transceiver: internal MDI-X: Unknown Current message level: 0x000060e4 (24804) link ifup rx_err tx_err hw wol Link detected: yes driver: alx version: 5.15.46-Unraid firmware-version: expansion-rom-version: bus-info: 0000:03:00.0 supports-statistics: yes supports-test: no supports-eeprom-access: no supports-register-dump: no supports-priv-flags: no

If I use this function and create share. Under windows I can see this share and folders but I cant do anything else. No access to folders. There is no option to setup any credentials.