[*** Guide *** Setup WOL for UNRAID]

Hi,

 

My on board network card doesn't support wake on lan on unraid so I bought USB Network Adapter 2.5Gbp (no pci slots available on motherboard) and I still cant wake up my machine. In bios I have enabled resume by PCI-E devices. Do I need to enable resume by USB as well? If I turn off Unraid the leds on adapter are off. There must be no power. If I use this above command "echo -n mem > /sys/power/state" leds are on but I cant wake up machine any way.

[WOL and Killer 2200 NIC]

Hi,

 

I am new here and I do not have experience with Linux at all.

I build my NAS using my old Windows 10 PC and I noticed under Unraid WOL is not working.

Under Windows 10 WOL was working fine.

I did research and I found this NIC has a bug and WOL is disabled.

Is any way to enable WOL support?

Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supported pause frame use: Symmetric Receive-only
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: Yes
        Advertised FEC modes: Not reported
        Speed: 1000Mb/s
        Duplex: Full
        Auto-negotiation: on
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        MDI-X: Unknown
        Current message level: 0x000060e4 (24804)
                               link ifup rx_err tx_err hw wol
        Link detected: yes

driver: alx
version: 5.15.46-Unraid
firmware-version: 
expansion-rom-version: 
bus-info: 0000:03:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no

 

[Add root share button]

If I use this function and create share. Under windows I can see this share and folders but I cant do anything else. No access to folders. There is no option to setup any credentials.