drslevy

Yup, I have switched this off once I completed all my research and checks. I had a bad drive a few months back and that's when I turned it on. Then i got the errors and folowed up on it so I'll see how it goes for the next few months.

I set it to correcting in the scheduler. I know its different from the on one the main page. Thanks for the additional info though. Hopefully I'm good going forward.

The first 3 were correcting parity checks. Just to make sure we are referring to the same thing. the " Write corrections to parity disk: " option was checked for the first 3 scans. Then i ran a 4th one, which still had the same # of errors and then the last scan was ran with this option unchecked.

So what youre saying is that the Parity check has fixed 126 errors in the past but now I'm good?

Thanks @JorgeB. This will all take 2 to 3 days, I will update once completed. Update @JorgeB. Correcting completed with the same # of errors - 126 and then the non correcting completed with no errors. I have attached the logs just in case but what exactly does this mean? I'm still a bit new to Unraid so I just wanted an explanation so i know what to do in the future. Thanks in advance for the help. theforce-diagnostics-20240319-1406.zip

Thanks @JorgeB. This will all take 2 to 3 days, I will update once completed.

Update - The diagnostic file was after a reboot because i had to reboot to complete the memory test sooooooo should I run another Parity test or whats the next best step here?

I've been busy with work and life so I'm finally getting around to trying to figure out whats going on here. I have my parity check running once a month and the last 3 times it ran, it has exactly the same # of errors. no drive errors and I tested the ram, no errors there either. I have attached the diagnostics logs. I have 2 parity disks and I also have write corrections to parity disk checked. Thanks in advance for any help provided. theforce-diagnostics-20240314-1118.zip