CrunchyWalrus

12 Power_Cycle_Count -O--CK 100 100 000 - 50 192 Power-Off_Retract_Count -O--CK 200 200 000 - 48 These SMART values seem very high for a drive that was taken out of the packaging and put in less than 24 hours ago. Definitely think there is a power issue now.

My AppData is already set to just use the Cache drive(s), but good point on the System share. I will change that to use the Cache too. I don't use the Domains folder, only running 1 VM and it uses a SATA SSD directly passed through to the VM.

The original drive showed bad sectors when I plugged it into a dock into my PC, so that was for sure faulty, but sounds like I have a different issue now. I will check physical connections and replace the sata cable for good measure this evening.

Hey all, I had a 4TB drive that started producing some errors so sent it in for warranty and just received/popped the new one in last night. Now I'm getting the same errors as before. Is it possible my parity is messed up and the errors are coming from the rebuild? Thankfully there isn't anything important on this drive, that said if it is parity errors how would I go about completely removing this drive from the array and re-adding as a blank new drive? Diagnostics attached. Cheers! tower-diagnostics-20230207-1302.zip