anwsmh

Thank you warpspeed. I will give it a try although my Kodi is on an unfamiliar platform (Kodi for Android) and I am not sure I can get at autofs. Apparently there is no autofs in Android (and the A distro I am using is nailed down by Amazon), so I can't use your suggestion. From AI, "No, Android does not have a native equivalent to autofs for mounting NFS shares. Unlike standard Linux distributions, Android lacks the autofs daemon and does not support on-demand mounting of NFS shares out of the box. Accessing NFS on Android requires manual intervention or third-party workarounds, and almost always requires root access"

I have been using NFS v3 since Unraid v6. With the announcement about v4 support in 7.3.1 I had the same problem as the OP ie Kodi v21.3 can't connect to Unraid NFS server using NFS v4 (NFS v3 continues to work fine. Note that after changing the Kodi client to use v4, the Library source was also edited to exclude the physical path to the share root, as I understand is necessary with NFS v4) The Kodi log reports, NFS4: SETCLIENTID (path /) failed with NFSv4ERR_MINOR_VERS_MISMATCH (-5) after a connect failure. On the server, the "/proc/fs/nfsd/versions" file has +3 +4 -4.0 -4.1 -4.2 perhaps consistent with the Kodi failure message if Kodi v21.3 can only support v4.0 of NFS v4. Is there any way to allow NFS v4.0 on Unraid ? (While Unraid & Kodi are on the same Gigabit LAN, when I was using SMB on Unraid v6, it wasn't possible to play 2160p movies without pausing, stuttering & loss of audio. NFS v3 allowed such movies to be watchable. I was hoping for additional performance benefits, compared to NFS v3, with v4)

Worked brilliantly instantly. Thank you very much FlamongOle..

All disks shown in "Empty tray" colors. Latest Unraid (gen release), latest Disk location plugin, configured only for geometry (number, orientation and numbering) and manual tray allocations ((as I have done before when running a shelf, without problems). Now, the Disk Location plugin after a Force Scan All and some days of running) shows all disks with the "Tray Empty" colors ie does not show Parity in Red, Data in Blue etc (standard colors no custom) I'd be very grateful for any suggestions or directions for collecting further info. Thank you. (Very grateful for this plugin. It normally does what it says without fuss and minimal thinking. And it is so very helpful. For example, I was going to check the Unraid emulation of a faulty disk and want to be sure that the disk I pull is what I think it is.)