rustyshackleford140rainey

I disconnected the disk from the HBA and plugged it into a SATA port on the motherboard and ran a rebuild. It worked perfectly. Thank you for all of your help and with reviewing the information, I really appreciate it.

Thanks for the reply. How could you tell if it's a power issue? Should I change the power connector to the drive or change the power supply?

After completing a parity check I noticed that one of my disks became disabled. It appears there were a high number of UDMA CRC errors and read/write errors. I powered down the server and reset the cables to that disk and the others attached (including power cable). Then I started the array in maintenance mode without that disk, stopped it, then reassigned that disk and started the array again so that disk could be rebuilt upon itself. As that disk is being rebuilt currently there are more UDMA CRC errors appearing (currently close to 500). I have already ordered a new cable but it wont arrive for a few days. I have posted the diagnostics that were saved prior to resetting the cable and reboot. The drive with issues was just purchased from serverpartsdeal.com and has no data on it. Any help with review of the diagnostics would be greatly appreciated. zeus-diagnostics-20240323-1124.zip zeus-smart-20240323-1025.zip

Hello I'm new to Unraid. When I start my system there are hundreds of lines flashing. When the system starts it shows that the system log is at 100%. After looking at the logs it appears all the messages say PCIE Bus Error. I'm not sure what that means. For reference I'm using a LSI-930016i in the top slot of my ASUS Prime Z790-V Wifi Motherboard. Previously the HBA card was in a different slot that only offered x4 lanes so I switched it to the top slot. After doing that I normally have a bunch of lines being output at startup and my system log being at 100%. I have included the diagnostics zip file for reference. Thanks for your help. tower-diagnostics-20240224-1853.zip