Tim Timmens

Members
  • Posts

    62
  • Joined

  • Last visited

Converted

  • Gender
    Undisclosed

Tim Timmens's Achievements

Rookie

Rookie (2/14)

0

Reputation

  1. It's funny, I saw something about IRQ come up but didn't think much of it as they would go away after a few minutes. I have also recently changed monitors to a HDMI TV instead of a dedicated monitor. I will have a look at the syslog and report back. I will also change the SATA cable, hopefully something works.
  2. I have replaced the disk with a new WD Red 3tb disk. Still the same issue. 30 hours into a pre-clear and only on stage 2. Any ideas? Thanks
  3. I still have some kind of problem. Began the preclear again and on disk pre-read stage, it was reading the disk around the 120MB/s. At 70% stage, it began to read at 2.3MB/s and has been at the speed since. Should I try to connect the disk to motherboard port or is the disk in need of replacing? Thanks
  4. oh okay, brilliant. So to fix my issues, I will disconnect the new HDD that I was pre-clearing. I will make sure all cables are connected good. Then I will try again with the new HDD. hopefully it should pre-clear in the normal 24ish hours it takes. If it's still slow, then I shall report back. Thanks
  5. So I need a new power supply? :'(
  6. Single Rail? I don't know if it's a single rail or not as I don't know what you mean. My power supply is a Corsair AX760.
  7. It's a 750W power supply. I'll take it out and check the cable and re-do the pre-clear.
  8. OKay, aborted the pre-clear with controlC. Obtained smart report. I have attached it, is this HDD faulty? Thanks smart_report.txt
  9. How do I abort it? And is the smart report on the USB?
  10. I am currently using pre-clear tool on a new disk. It's on the final post read part but it's taking ages. Normally a 3TB disk is done in just over 24 hour mark, currently the post read is taking absolute ages. It's been post reading for the last 10 hours at 2.6Mb/s and has completed just 2%. Overall the pre-clear has taken 34 hours and counting. Could this be a faulty disk? Can I make this step quicker? By my calculations, at 2.6Mb/s will take months!
  11. I have finally got access to my server, but still a problem lingers on that when transferring data to the server transfer rate is 1mb/s instead of the normal 50mb/s. How do I go about assigning ip address on the router? Thanks
  12. Shall I just change the ip address from 192.168.0.110 to 192.168.1.110? Thanks
  13. I have tried to access it from 2 computers, two phones and an iPad, just never connects. For example, the Mac I am currently using has the ip address 192.168.1.101 Thanks
  14. I have attached a pic of what appears when I type the code. I have tried using the 'inet addr' ip address but I have had no success.
  15. I tried the following: ping www.google.com I got the following: ping: unknown host www.google.com What does that mean and how can I resolve my issue? Thanks