DracZ

Just a quick update to the situation - I purchased an LSI 9207-8i off eBay and the card was immediately plug n' play with zero issues from first boot. Didn't even require the tape mod to POST.

Pretty much the same experience I had with the B450M Pro4 setup, apply tape and it was good to go. Your setup seems like 90% similar, no idea what's going on with mine. I just ordered a 9207-8i so hopefully that'll be a plug n play. Thanks again for the reply!

I didn't think it would be either to be honest lol. I've already tried the tape mod, but it doesn't seem to be doing the trick on the E3C236D4U. The heatsink is definitely warm to the touch but the green status LED remains off. Am I missing a BIOS setting somewhere maybe?

Thanks for taking a look JorgeB, appreciate you taking the time to confirm my suspicions. Would an LSI 9207-8i be a better bet you think? or perhaps a non-OEM 9211-8i?

Hi everyone, I recently purchased a pre-flashed IT mode Dell H310 and have had absolutely no luck getting it to run on my unRAID box: Setup 1 (unRAID): Xeon E3-1245v6 ASRock Rack E3C236D4U (Intel C236) 16GB DDR4 ECC UDIMM Setup 2 (HTPC) AMD 2200G ASrock B450M Pro4 16GB DDR4 Windows 10 Pro So far the cards been working perfectly in the seller's Dell R720 (Windows Sever 2008) as well as my own HTPC (Setup 2) with no issues. It also seems to be running the correct firmware (20.00.07.00) / bios (07.39.02.00) as shown in the picture attached to this thread) This is what i've tried so far: B5/6 Pin Tape Mod (card would not POST in the HTPC without it, but works perfectly with the mod applied, for the unRAID box it will POST with or without the mod, but the card is still not able to be detected either way) Swapping PCI-E slots (tried both the x16 / x8 slot on the E3C236D4U) Tried different CSM options (Legacy only and UEFI only) Besides the card's BIOS not being visible upon boot, I've also noticed the green LED on the card is also not lit when plugged into the E3C236D4U. When using the following command in the unRAID box: sas2flash.efi -listall I get: No LSI SAS adaptors found! Limited Command Set Available! ERROR: COmmand Not allowed without an adaptor! If anyone has suggestions or anything else I could try to get this to work I'd really appreciate it. Thanks for the help in advance!