Earache

Fixed. Here is what I did this time. 1)Stop Array 2)Assign Seagate 3TB to parity 3)Started array 4)Let it parity sync 4)Stopped array 5)Assigned WD 2TB (old parity) to disk 3, which resulted in not being able to start the array (see pictures above for reason). 6)Pulled some hair out 7)Tools > New Config 8)Pulled out hair once again because it wasn't resetting. 9)Rebooted 10)Tools>New Config (YAY IT WORKED!) 11)Reassigned drives and formated WD 2tB 12) Posted here. My next question is how do I update from unraid 6.0-beta10a to the latest without losing my dockers/setups?

I'm looking to get Dynamix on unRAID 6, but have no idea where to start and have search everywhere for an answer. Can someone point me in the right direction?

So New Config only wipes array config and nothing else?

Disk 3 was unassigned. Here's what I did prior to my screenshot 1)Assign Seagate 3TB to parity 2)Started array 3)Ran the course of parity-sync 4)preclear on WD 2tb (Disk3) 5)stopped array 6)attempted to assign WD 2TB to Disk 3 I'm completely stumped. Does 'New Config' wipe data off the drives or is it just the unraid configuration?

For my parity drive, it still says Wrong, even after I assigned the 3TB Seagate to Parity, did a parity-sync, ran a preclear on the WD 2TB drive. I don't know what to do now

Ok doing a parity sync on my new 3TB drive. After that will preclear the old parity drive (2TB) and readd it to the pool. Thanks guys.

I have a full license. Should I pre-clear the old parity drive before doing anything? Included a screenshot

I should pre-clear onces the parity-sync is complete?

I purchased a 3TB Seagate to replace my 2TB WD parity drive. I'm having issues not being able to assign my old 2TB to a disk. What I've done is: 1)Shutdown 2)Install new 3TB drive 3)reboot 4)Assign 3TB drive as Parity 5)Ran Parity-Sync After the parity-sync, I can't assign my old 2tb as disk 3, it gives me a invalid array. I don't know what to do and do not want to lose my data. Any help would be appreciated.

So apparently I did something to mess up my working CP docker (was fine for 3 months). I haven't touched a thing, but it will not start, and says the port is in use. I went and removed the container and image, re-installed. It now starts but I cannot access the webpage. I don't know what's going on. Any ideas?

For some reason NZBDrone refuses to download anything automatically (if i run an episode scan on a season), I have to download via the manual route. Also it does not move files at all, they are all sitting in my download folder. I'm pretty sure I have it configured properly (copied my previous config, and changed folders etc). Any ideas?

I get Unable to Connect when trying to access the page. Can someone post a sample config.js?