TheMannequin

Olla, I've recently noticed that when all my disks have been spun down, and I access Plex, it does NOT spin up the drives, and shows an error in Plex when trying to browse my Library. Only when I manually spin up a drive (any drive) does the Library's show again in Plex. Any idea? Thanks!

Had to set timeouts to almost 3 min! but it's doing clean shutdowns now .

Hi again, Ok, I changed timeouts for disks to 120 and VM's to 100 but still getting unclean shutdown.... latest syslog attached tower-diagnostics-20230313-1006.zip

Thanks, will change and see how it goes. Will feedback on results. No, using purely for clean shutdowns....but with our "incredibly reliable" power, I don't set it to shutdown immediately when power is lost...only after a few minutes.

Yes they are from the flash /logs folder (after I did the Mirror syslog to flash under settings) Those are the last 4 logs that was auto shutdown with NUT as UPS got low. The last manual shutdown I did, everything was good and NO unclean shutdown detected.

Is that not the ones I included in above post?

Hi, With the constant loadshedding in my country...no power for atleast 2 hours every 6 hours....my unRAID server is starting to have issues, and I can't pinpoint why. Almost every automatic NUT shutdown is now seen as an unclean shutdown, where it never was an issue before. And this causes a parity check to start, that can't finish because the next power outage is max 6 hours away.... I've attached the last for diagnostic logs, with SYSLOG set to mirror to the flash drive. I went through them, but not really know what to look for. Thanks for the assistance. tower-diagnostics-20230308-0610.zip tower-diagnostics-20230309-0406.zip tower-diagnostics-20230308-2212.zip tower-diagnostics-20230308-1412.zip

Hi all, I need to upgrade my disks, as I'm sitting at over 95% used now...BUT, I live in South Africa, and currently we get load-shedding every 6 hours or so.....that means no power. I have my server on a UPS for clean shutdowns. Question is will unRAID be able to handle the constant power outages while clearing disks and doing parity rebuilds etc? Thanks

Done!

Might not be related, but, do you perhaps have Sonarr installed? I had the issue on my server for a very long time where the Sonarr container would spike one core at a time as long as it was started. It stopped after the last update though.

Anyone have an idea how to remove the debug from the startup of the container?

Hi, I have posted in the container section, with no repsonse as yet: But, I do believe this canbe applicable to more than just the one container.... How do I change the startup command for a specific container? As the post above states, Sonarr is starting up with mono in debug mode....causing high CPU usage, and I'm sure if the debug is removed it will be fine.... Thanks!

Hi, My Sonarr container is using 1 CPU core at 100% constantly! After some digging, it seems it's starting up with '--debug' option.... how do I fix it?

Sorry to dig this up again..... Every found a solution? This is the only thread I found with my exact issue...

Hi everyone, I've been having a wierd issue since I started using the NVidia build to enable hardware transcoding in Plex via GPU.... When trying to stop my array, it can take almost an hour to shut everything down.... it sits at 'Array Stopping•Retry unmounting disk share(s)...' and I can even view the Log window as it's just blank. Where can I see what is causing it, or how to enabledetailed logging for it? Got the last diagnostics attached. See some DMA write errors...? Thanks tower-diagnostics-20210111-1057.zip