Kthwaits

Does anyone have Unraid running with an Alder Lake CPU and a W680 chipset motherboard (such as the Supermicro MBD-X13SAE)? I'm currently using a Z690 board but I specifically went with an Alder Lake i9 because at the time they had just announced that it would also be supported on W680 boards once they were available. The idea being that I would have the ability to upgrade my MB and ram to DDR5 ECC (which W680 enables for Alder Lake i5, i7, & i9s) later on. As of now there are still only a couple W680 boards available but I'm curious if anyone has tried one with Unraid yet and what their experience has been.

I’m also using this same mobo. Are you able to detect the fan speed? I can see CPU and MB Temp sensors but none of my PWM fans can be seen within Unraid. Currently running RC4 Edit: Was able to solve the PWM fan issue by following these instructions from a different thread. Turns out its not a Z690-specific problem like I assumed.

Sorry about that, I streamed something from plex and recreated the problem. This is the diagnostics from immediately after the server became accessible online again just now. kthwaits-diagnostics-20171014-2129.zip

Hi, my unRAID setup just recently ran out of space so I did a parity swap and used the old parity as a new data drive. I've been having some troubles with Plex since then, although I'm not sure that its related to that. Every time I stream something from Plex, it gets about two minutes in before the entire server goes offline (plex stops, cant access webUI, ssh, etc) and then stays offline for about ten minutes. When I am finally able to view the webUI again, it shows that the uptime is uninterrupted and I didn't see anything too strange in the logs. I've installed the fix common problems plugin and received a message that call traces have been found on my server and that someone over here may be able to provide me with some assistance. I've attached the diagnostics - any help would be appreciated! kthwaits-diagnostics-20171014-2022.zip

Well it passed the extended smart test so I rebuilt it last night and it seems to be back functioning normally. I wonder what caused the drive to fail at all in the first place. Thanks so much for all the help and for saving me from buying a whole new drive!

Sorry about that, I'm relatively new to UnRAID and all of its workings. Here is my syslog. Still not entirely sure how to interpret a lot of this information. syslog.txt

I'm really sorry if this type of post is frowned upon but one of my drives has a red x next to it and I want to be sure it needs to be replaced before I purchase a new one. I've attached the SMART report. Thanks in advance! smart.txt