Tegeril

Drive rebuild completed without issue, all the files are there. Thanks for taking the time to give me some feedback

I checked over the smart report for the drive, there was nothing amiss in any of the potential problem areas. There's not too much data on this particular drive anyway and I did already start the rebuild, so we'll see what happens

No SMART errors reported, short test passed, going to rebuild that drive.

I did not cancel the parity check, the web interface showed it was at idle. Web server is back - had to restart to get any interaction from the system and disk4 is still flagged red. Is there an easy way to reset the disk and run another parity check? (Is it unassign, start, stop, assign, start?) Edit: Nevermind, found the wiki again, going through the steps.

Power was lost long enough while I wasn't around for the UPS to drop as well and the unraid system went down. I brought it back up a couple hours ago and just went to check the control panel to find that it must have done a parity check upon reboot (~500k reads on parity plus drives 1-3, but no reads on drive 4 and 134mil writes and 576 errors). Told the array to stop...and now it's stuck. Parity shows Free: - the rest show "Unmounting". Not sure what I should do here. Any help would be appreciated. Edit...and now the web server just stopped responding. AHHH

That coupon has been around since mid-July.

I, of course, would still love to see a second parity volume Though I'm more curious what the current "official" list is, ie: what is already planned for 5.0 from past requests.

Is there one of these for the initial 5.0 release? I see a clear focus on certain goals (plugins, webgui, etc) and an obvious need for filling in the features that are not yet in that exist in previous versions, but not a whole lot of "these are the things that will hopefully make it into release." If I missed it, feel free to point me on my way