Arioch77

Well, when i said "only CPU and RAM " it was without the the IPMI card the behaviour seem to point to the battery, but since asus doesnt want to tell me if i can ( or cannot ) touch this covering ... Do you remember if you have this covering too ? ( or can easily check it ? )

Thanks for answering ! I also have the ATX board, with IPMI card There is no jumper on the reset pin, there is a jumper on chassis pin ( but disabled by default on the bios ) Tried on a cardboard and in a case, it does the same with only CPU + memory on the two card... As it only do that on cold boot ( so only when power is down from the PSU for more than x seconds ) was thinking about the battery, but it's secured behind some black heat shrink thingies. Granted, the PSU is an old 400W corsair with only 6 ( or eight ? ) CPU and 1 PCIE , i dont think it's the cause. Already did a memtest without error and a stressng for 1 hour without issue. Losing sanity :/

Hi, Got this motherboard to let my old bi xeon UNRAID build retire, but runing on a issue. Each time i do a cold boot, i lose all BIOS parameters ( clock and date too ) , like the battery is dead, from linux, after activating the good modprod, i can see the battery at 3.12V. No jumper on the clear bios, jumper on the chassis, the baterry is under "what appears" to be head shrink tubbing and ASUS won't tell me if i can "cut it" to change the battery. Vendor sent me a replacement from another batch, but same issue, so I don't think it's hardware related, and asus isn"t helping at all ( aka : "see with you seller " ) Bios was updated to 4505, ME to the lastest version, IPMI to 1.1.40. I'm at a loss there... Saw that some of you had this exact same problem, have you got this figured out ?

Hi, Tried to add a pair of new drive to replace failing ones, but they won't show up in unassigned device. Strangely enough they appear in lsblk : sdq 65:0 0 7.3T 0 disk └─sdq1 65:1 0 7.3T 0 part sdr 65:16 0 3.6T 0 disk └─sdr1 65:17 0 3.6T they appear in "disk location" too. As they are Western Digital MyBook that I schunked, tried to cover the 3.3V line with no result. Tried to put them in another tray, same diagnistic. They work in others computer, can format them just fine and can't find any error in SMART. If someone have any idea, would gladly take it. Thanks in advance. yggdrasil-diagnostics-20210925-2105.zip