Hey everyone, first off, I appreciate anyone who looks at this. Hopefully I haven't goofed up too much.
I lost my flash drive so I went digging through the forums to get everything set back up. I had an old backup from before I had an HDD fail. Its not TOO far behind what my current setup actually is.
I have a screenshot of how everything was setup recently because I was sharing it with a friend who was setting up their own unraid.
This is the configuration of the last good working state:
Parity - 1x 4tb disk
Cache - 128gb SSD
Disk1 - 4tb disk
Disk2 - 1tb disk
Disk3 - 4tb disk
Disk4 - 3tb disk
My current issue is that I'm not sure how to proceed. I have the array looking exactly like it should with the proper disk serial numbers in the proper disk slots. All devices are setup the same as my most recent screenshot. Unfortunately, disk1 is showing that its "wrong disk" so I'm assuming this backup was from before I replaced the failed one. Its also currently showing disk 3 & 4 as new devices.
This is how it currently looks.
Parity - 1x 4tb disk
Cache - 128gb SSD
Disk1 - 4tb disk (Wrong Disk)
Disk2 - 1tb disk
Disk3 - 4tb disk (New Device)
Disk4 - 3tb disk (New Device)
How do I proceed without losing the data?
Thanks everyone!