dogmatic69
Members
-
Joined
-
Last visited
-
Completely gave up on unraid and installed ubuntu on a spare disk. After reboot no display!!! Too much time later I finally find newer kernal changed some amdgpu.dc setting in grub and turning back to the old value results in a working-ish display. Will potentially retry unraid but been thinking of switching back to direct hardware and maybe building a seperate raid box
-
Ok, rolled back to 6.7 and now that wont load either. The GFx does something, but only flashing two cursours and a few minutes later I get some kind of RGB lines across the whole screen and a lot of errors about some device (assuming gfx) being busy
-
I'll try roll back the update for now
-
Adding that iommu config did not seem to do anything. I've since retried every possible combination of passthrough i can find. Also figured I'm in deep so might as well update the bios. No help either. Latest diagnostics attached with what I believe to be close to original (ubuntu test this time) > removing the line Which line? The whole append? The iommu added bit? tower-diagnostics-20220615-2211.zip
-
Upgraded from 6.7 to 6.10 and my VM will not boot with the GFx attached. Boot's fine with VNC VM in question is named "ubuntu", the other two are old an no longer in active use As soon as the VM is started the lowest of the assigned CPU cores hits 100% and stays there. If I change the assigned cores to one, that is the one that gets pinned to 100%. In either case all other cores are at 0-1 % I've left it for a long while (over night) and it never boots. Can't see anything in the logs, I've tried various machine types, i440 worked previously, not now, neither does Q35. Also have tried recreating the VM from scratch attaching the old disk image but still wont boot. Card is AMD RX 570 + Asus Z97 extreme 4 + Intel i5-4570S edit: Also tried power down and booting fresh in case the card is not released, did not help tower-diagnostics-20220615-1847.zip
-
I am running my unRAID with a domain name internally. When I update apps and docker images the json responses are blocked due to CSRF settings for some reason. Only able to work correctly when using the IP address. Additionally I want to run unRAID in the orginizer app but again, updates are blocked with errors about being run in an iframe. The rest of the site works just fine in the iframe.
-
Performed an update of a docker image (zoneminder) and it had an error at some point in the update. After which my zoneminder image was gone and there was an orphaned image in the list of docker images. I was not able to get it running again so had to kill the orphan in cli and recreate the image from scratch.