Sutonimh

Was looking at my logs troubleshooting an issue and noticed eth0 is constantly renaming itself. See excerpt from the logs below. Looks like it does this several times every 10 minutes. eth0 is the primary interface for this particular machine. The majority of my docker containers are setup on another physical interface but there are a couple on the bridge for eth0 or host network. Is this normal behavior? My logs are full of these messages. Aug 3 16:00:06 Charon kernel: vethaf0a961: renamed from eth0 Aug 3 16:00:07 Charon kernel: eth0: renamed from veth9464cb6 Aug 3 16:10:06 Charon kernel: veth9464cb6: renamed from eth0 Aug 3 16:10:07 Charon kernel: eth0: renamed from veth526c145 Aug 3 16:20:06 Charon kernel: veth526c145: renamed from eth0 Aug 3 16:20:07 Charon kernel: eth0: renamed from veth33f43ba Aug 3 16:30:06 Charon kernel: veth33f43ba: renamed from eth0 Aug 3 16:30:07 Charon kernel: eth0: renamed from veth79c3329 Aug 3 16:40:06 Charon kernel: veth79c3329: renamed from eth0 Aug 3 16:40:07 Charon kernel: eth0: renamed from veth61aeb11 Aug 3 16:50:06 Charon kernel: veth61aeb11: renamed from eth0 Aug 3 16:50:06 Charon kernel: eth0: renamed from veth6685806

I do have one VM setup using SeaBios, but it's not currently running.

I've been having an issue I've been ignoring for quite some time now that I'm hoping some generous soul can help me with. With a monitor plugged into my machine Running Unraid 6.9.2 everything boots up just fine and I can see/interact with the bios and various raid controller dialogs. The boot loader loads normally and I can see the dmesg output as the OS is loading on the monitor. However with either the console or gui mode once the OS is loaded my keyboard goes non responsive. In console mode I get the login prompt but I can't type anything into it. In GUI mode it just shows the end of the dmesg output on the screen and no prompt. Tried all the usb ports no change. I recently decided I was sick of it not working so started with a fresh install on another usb drive and the issue is still persisting. Anyone able to get me pointed in the right direction to to figure out what the issue is?