PsyVision

It completed a parity check last night with 0 errors. My syslog can be found at: http://www.delimits.net/richard/syslog-2009-02-07.txt The only thing I see in there that is worrying me - although it has recently entered the log is: The smartctl reports for the three drives can be found in: http://www.delimits.net/richard/smart-sda.txt http://www.delimits.net/richard/smart-sdb.txt http://www.delimits.net/richard/smart-sdc.txt Some further information is that the system is doing a sync at about 55MB/sec and will also wake on lan using the magic packet. To make that happen I had to use 'ethtool -s eth0 wol g' to set the 'Wake-on' to 'g' however, upon rebooting it has gone back to 'b', should I place the ethtool command in my go script?

This sounds good to me - I can see why you suggested this after posting a reply in my thread earlier today. Maybe something should be added to some of the wiki pages as a post-install 'check' as although I followed the steps to install and then configure unRAID, I did not see anything to say to carry out a further check, plus to check syslogs - although some might say this is something one should do as a matter of course.

I have only copied data from other sources at the moment onto it so i've got two copies still. I'm going to run a full check overnight tonight and will then take a look at the logs tomorrow - cheers for the headsup on that.

Hi, I've just built an unRAID server so thought I would share the hardware I'm using as setup wise it has worked flawlessly. Obviously I need to leave it for a couple of weeks to make sure it remains stable but the fact it is booting fine is a good sign Motherboard: ASUS M3N-HD/HDMI nForce 750a SLI - 2x 16xPCI-E, 2x 1xPCI-E, 6-SATA with USB Booting, HDMI and VGA output (Onboard Graphics) CPU: AMD 4850e X2 RAM: Corsair 2x1GB 4-4-4-12 Hard Drives: 2x 1TB WD Caviar Green, 1x 500GB WD USB Stick: Freecom DataBar 8GB The case used was a Silverstone KL01 as a) looks nice b) provides accessible drive bays down the full front of the case (lots of room for Icy Dock caddys). The Freecom USB stick isn't the fastest but thats not too important I guess. I'm currently running unRAID 4.4.2 with BubbaRAID. The only initial problem I had was that I couldnt get the Realtek NIC to work but that appears to be because I forgot to name the flash drive

I am about to carry out a build using this board as I want one that is known to at least partially work - and with room for 2x Adaptec 1430SA PCI-E cards. However, I am not sure what CPU to go with? Either a dual core (something like an X2 4850e) or a single core LE-1640. Would a dual core make much of a difference and is there a possibility of it working with unRAID 4.4?