Solutions
-
LoudRex's post in [Solved][6.12.4] How to get better internet speeds? was marked as the answerSolution was that the cable plugged in from the Fritzbox wasn't properly connected to the first switch.
I jerked a little at the cable because I saw it was plugged in but the port was not blinking.
Then it blinked again, seemed that the connection wasn't good.
Though tested the LAN cable with my new apparatus, and the cable was ok.
Thanks for helping me through this one!
-
LoudRex's post in [SOLVED] [6.12.2] Problems after failed parity check and swap was marked as the answerSince there went some more wrong, I just had to reset my qbit dockers.
Forgot to make a backup of my appdata folder, so 4 new and fresh qbit dockers.
So this one is solved, and I shall mark it so.
Thanks again.
-
LoudRex's post in (SOLVED) Docker NginxProxyManager not working anymore was marked as the answerThanks @JonathanM for the information:
It is about the docker image from Djoss, so that is my next stop.
Greetings, Rik
Edit: I've solved it, my router was reset a few days ago and missed one port setting for port 443, added that port to my router config again and ka-ching! Solved!
