p.wrangles

Definitely not New Config! I booted in maintenance mode, clicked disk one, did check then fix, then rebooted

After i fixed the drive the array just started

I cancelled the rebuild yesterday and repaired the filesystem first - I haven't rebuilt yet, let me know if i should? ppnhost-diagnostics-20251005-1926.zip

okay, disk repaired all looks good, should i unmount the disk and remount to rebuild ontop again?

This is an existing dish. How do I repair the file system? Format the disk?

new cables installed and rebuild started ppnhost-diagnostics-20251004-1639.zip

There are some important things that i dont have a backup of.

Am i at risk of loosing any data?

So what do i do now? just stop the rebuild?

just started the rebuild, this looks bad ppnhost-diagnostics-20251003-1904.zip

In the meantime i swapped one over Swapped the sata cable in disk 1 and the sata cable in parity. any changes in the logs.ppnhost-diagnostics-20251003-1526.zip

Im going to buy some more cables and replace what i currently have 1 by 1.

Interesting, Its only disk one with the cross?

Ive replaced the cable on Disk 1ppnhost-diagnostics-20251002-0924.zip

Sorry!ppnhost-diagnostics-20251001-1839.zip

Just rechecked everything, unplugged and pluged back in ppnhost-diagnostics-20251001-0828.zip

ppnhost-diagnostics-20251001-0828.zip

Ive checked the cables and they are all seated correctly, is there anyway i can clear the errors and recheck? how can i rebuild on top of the error is still present?

As Requested ppnhost-diagnostics-20250930-0910.zip

Hello, The other week I had a disk fail (disk 3), reported with a red cross in UNRAID and the disk was making an awful noise. I just replaced it and then started to rebuild the array from parity. Once the array had finished its rebuild from parity, another disk (disk 1) is now reporting as failed - I have done some extended smart checks and everything comes back without error.WDC_WD40EFRX-68N32N0_WD-WCC7K0JZJR4K-20250929-1943.txt I attached the logs for the disk,

Is anyone able to assist with this. Logged on this morning and 5 containers had deleted themselves.

Hello I have recently been having an issue with my docker containers. They keep deleting themselves (seemingly randomly) and its not always the same containers that have the problem. I set them up and they run for several hours or days, then i log in and i see the container has been deleted (but the image still exists). Attached diagnostics for reference. PPNHOST Diagnostics 20240517.zip

Hi All, Visiting an old thread! I have recently had problems with my UNRAID Server and it crashes and reboots without warning. I was looking to set up PRTG on a raspberry Pi (looks like they have an alpha for this at the moment). Did anyone ever set this up - or do you know if there are any UNRAID specific PRTG sensors?

It just crashed again and i see nothing in the logs - My server runs a lot of my home automation and would be a real pain if I had to disable the dockers for a few days. Is there anyway in UNRAID that i can test things like the Flash Drive, CPU or RAM to see if there is any issues with them?

Its crashed about 30 minutes ago. Turns out that I already had syslog set up! I have attached the syslog. I did notice that this time when it booted back up again it wouldnt boot into unraid. i have to unplug the flash drive and plug it back in, Ive never had to do this before. Could this mean that the flash drive is at fault? syslog-10.168.40.1.log