bobC

Looked hopeful but no sensors found

Output from sensors detect is nill

having some issues with System Temp and Fan Control plugins. Had both plugins working for some time until I replaced mother board/CPU. now with with system temp I get "no drivers detected" and for fan control it shows "None" for PWM controller. I'm running Version: 6.12.0-rc3, and changed from a Asrock to the Asus MB I also read that Perl install is not required for 6.11 and up. and its no longer in the nerdpack Any one else experiencing problems, or have any suggestions? Bob

both replies were very helpful, I understand now, i just hope i can remember it haha thanks for the info Bob

the pic of the dashboard memory panel show the percents of how memory is being used, above this is the stats memory screen the two dont seem to correspond, I don't under what the percents are representing, adding them all up its more than 100% so I am a bit confused, did not find any definition in the forums or manual, if anyone cant point me in the right direction for some info. thanks in advance Bob

is there or can anyone provide a quick guide to creating a zfs zpool in unraid 6.12.0-rc2? through trial and error I created a test pool, then deleted it, now I don't believe I can replicate my steps, Thank you Bob

my flash decided to no longer boot properly, created a new flash from a recent backup, got back into unraid and selected replace a key, when going through the final confirmation, i get this error. can any one advise, tried in firefox and chrome. .

created zfs pool with (2) 8TB drives and (1) 4TB drive, unraid reports approx 8 TB of usable space, The ZFS Master plugin reports approx 11 TB which to believe, I assumed 50% usable or 10 TB any ideas ?

Thank you, I was not aware of that, lucky the drive is still intact but there was some data on it I wanted, luckily the files are accessible by mounting as an unassigned drive, so once parity restructure is done, I should be able to move the files over to the appropriate folders Appreciate the info!! Bob

Perfect, now parity is rebuilding thank you

I would like to permanently remove a drive from the array, if I unassigned a slot, it does not allow me to decrease total number of slots. I would like to remove a smaller drive and let parity rebuild the data on to other existing disks. anyone ever do this/ Bob

Think you are correct, the update appeared to be complete, but still showed prior version, so I manually did a reboot from the Gui, and it never booted after that, I took out the USB Flash and tried to read it in and tried to read in a Linux Machine and had read errors there also, I had a previous flash backup and restored on a new flash and pulled down a new key, everything is now update and appears to be working fine! Appreciate the response. Bob

I am getting a device descriptor read/64 error 110 and then cannot mount /dev/sda1 - press enter to reboot, I can not boot into safe mode either, same errors any one have any suggestions i can try ? image of booting log attached

Updated 6.11.4 to 6.11.5 no longer can boot, any suggestions please?

all of a sudden, i can no longer connect to my unraid server (v6.11.1) using firefox (v106.0.1), chrome and edge work fine. We can’t connect to the server at ......a550a8283a0e9a169d.unraid.net. (abbreviated link) i can connect to the server by the ip address directly. could this be a certificate issue? The certificate is viewable in firefox, and is working properly on the other two browsers, any suggestions would be appreciated Thanks Bob

unraid-api restart fix worked for me also! thanks for the help