jbeck22

I am currently running a Dell R710 with 10 drives (including Parity), x2 1TB NVME cache drives and 48G of memory. I'm connected to a Dell SC200 Compellent SC200 (JBOD) through a LSI 9205-8e PCIe card. I have a Dell H200 HBA card as well. The cache drives are in PCIe slots too. I currently an NVIDIA Quadro K2000 GPU installed. I have the following dockers / VMs installed...this is pretty much all I want (at the moment) Docker Containers Plex audiobookshelf code-server NPM Redis Tautulli xteve Authelia Radarr homebridge Overseerr Sonarr Tdarr_Node Tdarr_Server SabNZBD Homepage Paperless-ngx Unifi Controller VMs Home Assistant Upgrade Requirements I would like to get out of the rack mountable form factor as well as ditch the JBOD. It is working just fine, but I think I can do better. Intel based CPU Better GPU (for Plex HW transcodes as needed as well as Tdar to transcode my media library Better fans = quieter...right now with the server and the JBOD it is VERY loud Better power consumption Depending on just HOW quite the whole new setup is, I would like to be able to play the occasional game or two on it, which means that I would need to be able to sit in the same room as the new server without going deaf Any suggestions? I have built tons of PCs in years past, but it has been a LONG time since I did a custom build, so I'm looking for advice. Managed to put this together after watching a few videos...thoughts? https://pcpartpicker.com/list/KZ2Twg

Can we add mods to this server? If so, how would we go about doing that?

I can't seem to get LL to connect to my SABnzbd install on my unRaid server. Sonarr and Radarr and others have no problem. I "save" my config in LL before testing, but nothing that I do manages to actually get LL to connect to SAB. Any ideas? Thanks!

I have formatted the cache drive as suggested. I can see better overall docker performance for sure, so big win there. I re-ran the diagnostics again, but this time I'm not seeing the file that should show me the status of the cache setup. I have attached the new zip file here. tower-diagnostics-20191227-1121.zip Maybe it is in a different file now, since I formatted the cache drive to xfs?

Yes parity is disabled for some reason. Not sure if the disc had some errors or not, but it disabled itself...not sure how to re-enable it.

Thanks Johnnie! Can you tell me how I can find that in the diag? I want to check it after I make your recommended changes.

I'm still running the trial. I ran the disk speed docker to make sure that my drives are performing as they should, and they are (originally my cache drive was only getting like 3-4 MB/s, now I'm at 150+ after an upgrade). Anything docker related is almost unusable, including start and stopping of services. Any help would be greatly appreciated! tower-diagnostics-20191226-1512.zip

I'm getting the same error as above. Any suggestions?