Puntoboy

I'm planning a new server build to replace a Synology DS1515+. I already have another Unraid server I use for backing up the Synology. The problem is the network cabinet I would like to put it in only 300mm deep and I have 4U space, tops. I can't find a single case that fits into that requirement but I then spotted this disk enclosure from Silverstone which would fit inside the rack, but I'd need to pair it with another 1 or 2U device to run UnRaid etc. and a RAID card to connect to the mini SAS ports. Ideally with two hot swap bays for SSDs. https://www.silverstonetek.com/product.php?pid=483&area=en However, this enclosure seems hard to get hold of. Maybe I can cut the drive bays off of a 3U server with a SAS expander backplane instead? My requirements for my new NAS are: As many hot swap bays as possible (8 minimum). I have 5 x 14TB drives I need to migrate from my Synology - I have a backup Plex Media Server and storage Sonarr/Radarr/NZBGet - Docker VMs Home Assistant host - Currently running on Proxmoxx (The HP Mini PC in the bottom of the rack) 10GBe NIC (SFP+ Ideally but RJ45 would be fine) I have a Mini-ITX motherboard (Asus ROG Strix X570-I Gaming) and a SFX-L PSU already so I could use those, but now I'm thinking another board might be better. Obviously the SFX PSU won't really fit into a 1 or 2U enclosure. If I can't find a solution, my final plan is a Supermicro SuperChassis 826E16-R920LPB as I can just about find space for it due to the height of it. But Ideally I'd like a solution that fits inside the rack.

I've recently added a dual port 10GbE NIC to my UnRaid server and since I've been having some problems with my network config. Eth0 is the onboard 1GbE NIC Eth1 is the first port on the 10GbE NIC I'd like to have both NICs connected to the same LAN. Eth0 for management, GUI, etc. and Eth1 for the SMB, VM and other traffic. I've assigned a static IP to both NICs, Eth0 has bonding enabled (I have tried to disable it but the GUI stopped loading). But if I try to connect to the IP of Eth1 I can see the traffic is going via Eth0. I ran an iPerf test and I can also see this was capped at 1Gbps. If I change the default route to Eth1, that may work I guess? But then all traffic will just come from Eth1 and Eth0 won't be used for anything.

OK managed to get most of it installed. Just easy-rsa. I can see what's wrong, the path to github is wrong. But I've edited the plugin to put the right path and still no joy.