I have created my first new build for unraid as I have been running unraid on a very old HP microserver.

My new build is on a Gigabyte Motherboard gigabyte h470m ds3h using intel 10500 processor using the integrated network card.
Tested the server out with ubuntu on a usb stick and connected to the network fine.

Have followed many posts about the network config but seem to be going around in circles at this point.
Tried both static ip and dynamic. I know my router is fine as there is already an unraid server on the network.

My last try was with the following network.cfg

# Generated settings:
IFNAME[0]="br0"
BRNAME[0]="br0"
BRSTP[0]="no"
BRFD[0]="0"
BRNICS[0]="eth0"
PROTOCOL[0]="ipv4"
USE_DHCP[0]="yes"
DHCP_KEEPRESOLV="no"
USE_DHCP6[0]="yes"
DHCP6_KEEPRESOLV="no"
SYSNICS="1"

But the MAC address never appears in the Interface eth0
When I run ifconfig I don't get eth0

I would appreciate any help out there. 

tower2-diagnostics-20201217-1821.zip

Try beta / RC1 new release

 

Thanks Vr2lo, that worked perfectly

So easy once that worked