Alexandro Posted December 27, 2020 Share Posted December 27, 2020 Hi all, I have exchanged my trusty old APC unit to a newer version. https://www.apc.com/shop/pk/en/products/APC-Smart-UPS-C-1000VA-LCD-RM-2U-230V/P-SMC1000I-2U The new unit is serving my needs and power requirements well, although i noticed important statistics are not visualized by the APC daemon. Nominal Power, UPS Load and UPS Load % are missing. I have researched the forum but couldn't find an answer. The APC daemon is obviously not getting any updates anymore. NUT is behaving the same way. Is there any way to tweak something in APC Daemon? My UPS is not supporting firmware updates so it cannot be solved this way from the UPS side. Will appreciate any tips. Unraid Pro 6.8.3 version. Quote Link to comment
MattyB Posted December 28, 2020 Share Posted December 28, 2020 i have a similar issue. so much for getting actual APC UPSs to work right with the APC Daemon Quote Link to comment
JonathanM Posted December 28, 2020 Share Posted December 28, 2020 12 minutes ago, MattyB said: i have a similar issue. so much for getting actual APC UPSs to work right with the APC Daemon apcupsd is not affiliated with APC, it's a third party program that tries to work with as many UPS models as possible. Try NUT, it's a similar situation but sometimes some models work better with it. Quote Link to comment
MattyB Posted December 28, 2020 Share Posted December 28, 2020 1 hour ago, jonathanm said: apcupsd is not affiliated with APC, it's a third party program that tries to work with as many UPS models as possible. Try NUT, it's a similar situation but sometimes some models work better with it. NUT? Is that a driver for UPSs? where would a fella get that? Quote Link to comment
Vr2Io Posted December 28, 2020 Share Posted December 28, 2020 (edited) Try enable the MODBUS protocol or other method in below post. Edited December 28, 2020 by Vr2Io Quote Link to comment
paperblankets Posted January 22 Share Posted January 22 I'm not sure if this will help some of you with APC 3000 hardware. After enabling ModBus (On the UPS, and in settings) I HAD to physically disconnect the USB cable before nominal power rendered. I bet I wasted hours trying permutations of things, and in the end that's all I had to do. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.