dirtyofries Posted December 31, 2020 Share Posted December 31, 2020 Can't make heads or tails of it myself, anyone have any advice? Leads to a complete hard lockup of the system. Always reboots fine, though. Running 6.8.3. Nothing has changed in the system, that I know of, since this began. Mem test came back clean. Quote Link to comment
JorgeB Posted December 31, 2020 Share Posted December 31, 2020 You can try this and then post that log after a crash. Quote Link to comment
theruck Posted December 31, 2020 Share Posted December 31, 2020 (edited) i would suspect hardware - memory, mainboard or PSU. check for blown or bold capacitors Edited December 31, 2020 by theruck Quote Link to comment
dirtyofries Posted December 31, 2020 Author Share Posted December 31, 2020 8 hours ago, JorgeB said: You can try this and then post that log after a crash. Thanks, I'll give it a go. That was a nice, easy tutorial. Quote Link to comment
dirtyofries Posted January 12, 2021 Author Share Posted January 12, 2021 (edited) Ok, here's the log after a crash. Interestingly didn't get a kernel panic this time, just became unresponsive and needed a hard reset. Leading up to this, the system had only been on a few hours, no changes to it from previous (it had been on over a week with no problem, only shut it down to switch a power cable). The log is full of stuff that isn't usually there, so I'm assuming it's indicative of the problem. Some of the symptoms were a few cores spiked to 100%, and then the system ground to a halt a few minutes later. If anyone has insights, I'd appreciate it. Thanks! diagnostic.rtf Edited January 12, 2021 by dirtyofries Quote Link to comment
JorgeB Posted January 12, 2021 Share Posted January 12, 2021 There's a lot of crashes but nothing that points to the cause for me, you can try running the server in safe mode without any dockers/VMs for a couple of days, if it still crashes running as a basic NAS most likely there's some hardware issue, if it doesn't start turning on the services one by one. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.