LSI SAS 9201-8i Not Recognized Correctly


2 posts in this topic Last Reply

Recommended Posts

Heya, I just purchased a LSI SAS 9201-8i to increase internal drive capacity. I noticed it shows up as the same device on both systems, but my main system does not recognize the attached drives. Is something in my configuration stopping it? Any help is much appreciated. I do not believe updating firmware or flashing to IT mode of 9211-8i will do anything. I attempted, but was not able to anyways.

 

It is recognized at boot and the correct amount of disks. It even works in my Windows 10 PC and another test system of very similar config.

 

IMG_6285.thumb.JPG.58cf182abe8516cfdcfd7af1359d5b30.JPG

Main system: Intel DQ77MK Motherboard, E3-1265Lv2

IMG_6288.thumb.JPG.5a646e868edb620d4fe5d68314c76708.JPG

IMG_6286.thumb.JPG.058900cb2390d00981f2460256718a23.JPG

Second system: Supermicro X9SCM-F, E2-1265Lv2

IMG_6289.thumb.JPG.dfab4bab89759d658ee860b70d34e77c.JPG

 

Diagnostics attached: tower-diagnostics-20210110-2100.zip

Edited by whoisdecoy
Link to post
  • JorgeB locked this topic
Guest
This topic is now closed to further replies.