Hi is there any command i can type in the console to check usage of the /tmp, I have my plex transcoding to /tmp but would like to see usage when transcoding. Anyone help out. 

cd /tmp

du -h

 

that will give you a list in M or G how big the Transcode directory is.

in the WebUI of Unraid though the Dashboard  in Memory under RAM will show you your usage.

Transcoding 1080p or 720p is pretty low Ram usage, if you are trascoding down 4K that can use a few GB's.

 

Yeah thanks very much worked at treat, i did notice ram usage increase in the dashboard but was just curious to see it in the console, transcoded 4k movie using hdr tone mapping and used about 3gb. Thanks again