rmoran Posted January 21, 2021 Share Posted January 21, 2021 Howdy y'all, newb here. I am building a NAS with unraid (so far so good) and have (2) GIG Ethernet cards on my motherboard. I have them both plugged into a switch, but only one seems to be enabled. It says Interface eth0 is pulling an IP from router but Interface eth1 one says "not configured" and at the bottom there is a button that says "PORT DOWN". I would ideally like to bond them in order to use 2 GIG on the NAS. How would I go about doing this? I have looked for documentation, but cannot find it. Thanks so much. Quote Link to comment
trurl Posted January 21, 2021 Share Posted January 21, 2021 In the eth0 settings, enable bonding and select a bonding mode Quote Link to comment
Interstellar Posted January 21, 2021 Share Posted January 21, 2021 Doesn’t the switch need to support bonding too? Quote Link to comment
rmoran Posted January 21, 2021 Author Share Posted January 21, 2021 16 minutes ago, trurl said: In the eth0 settings, enable bonding and select a bonding mode This is what is showing up. I cannot change them, they're grayed out. Enable bonding: Yes Bonding mode: active-backup (1) Bonding members of bond0: eth0, eth1 Enable bridging: Yes Interface eth1 Interface description: not configured Enable bonding: No Enable bridging: No Quote Link to comment
itimpi Posted January 21, 2021 Share Posted January 21, 2021 14 minutes ago, rmoran said: This is what is showing up. I cannot change them, they're grayed out. I think that you have to stop the array before you can make changes to the network settings. Quote Link to comment
trurl Posted January 21, 2021 Share Posted January 21, 2021 8 hours ago, Interstellar said: Doesn’t the switch need to support bonding too? 8 hours ago, trurl said: select a bonding mode Several are available. You can toggle Help on/off for the entire webUI by clicking the Help (?) button on the main menu bar. You can toggle help on/off for a specific setting by clicking on its label. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.