January 29, 20215 yr Hi all, I am using a netapp DS4246 with Unraid and I recently acquired interposers so that I can make use of some SAS drives I have access to. I went about adding the interposers to the existing drives today until I noticed that they are subtly changing the drive model names and as a result Unraid doesn't recognize them anymore. I reversed course and did some reading and it looks like the procedure is to add the drives to their correct slots and then run the New Config utility? Is that correct? And is there anything else I should know so that I dont mess this up 😅 Edited January 30, 20215 yr by alphablu
January 30, 20215 yr Community Expert 9 hours ago, alphablu said: looks like the procedure is to add the drives to their correct slots and then run the New Config utility? Is that correct? Yes. 9 hours ago, alphablu said: And is there anything else I should know so that I dont mess this up 😅 If the drives are unmountable after that don't format and post diags.
January 30, 20215 yr Author Ok, I went ahead with it and everything went smoothly. I'm back up and running. Thanks!
Archived
This topic is now archived and is closed to further replies.