Hankanman Posted March 2, 2021 Share Posted March 2, 2021 Hi All, just moved my unraid install and disks over to some new hardware. First issue was getting it to boot which was resolved using this post: https://forums.unraid.net/topic/74419-tried-to-upgrade-from-653-to-66-and-wont-boot-up-after-reboot/?tab=comments#comment-710968 Then I needed to remove a disk from the array (yes I probably should have done that before moving it) Followed these instructions to shrink array: https://wiki.unraid.net/Shrink_array#For_unRAID_v6.0_and_6.1_and_possibly_5.0 ( i tried the newer method but script didn't want to run, despite being sure i had done everything right) I am running 6.9.0-rc2 I created the new array and put my drives back in, started it up and it began parity syncing, all good, left it overnight to finish and came back to the web UI showing 90.1% done and unraid had crashed with the following on screen: Reset machine and it has started parity sync again, data is all there by the looks of it, but need to make sure this doesn't happen again... Quote Link to comment
Hankanman Posted March 4, 2021 Author Share Posted March 4, 2021 Update Have Tried Suggestions found on forums here: https://forums.unraid.net/topic/46802-faq-for-unraid-v6/page/2/?tab=comments#comment-819173 Updated Global C-State control to disabled in UEFI Set Power Supply Idle Control to Typical Current Idle in UEFI New Mother board and known good processor and RAM, current specs: 4x WD RED 4TB (3 in array, 1 parity) 1x WB Black 1TB NVMe (cache) ASRock B550 Steel Legend Ryzen 3800x 2x 8GB Corsair Vengeance LPX in dual channel All other UEFI settings stock aside from boot device and CSM disabled Lock up occurs as soon as 10mins after boot or longest it has been up is ~12 hours I've attached the last two lock ups and diagnostics dumps endeavor-diagnostics-20210304-0931.zip Quote Link to comment
jonp Posted March 8, 2021 Share Posted March 8, 2021 Hi there, Can you try replicating this issue on a stock setup? You have a number of plugins installed. Please boot either in safe mode or remove all plugins first. This will help us narrow down the cause. Quote Link to comment
Hankanman Posted March 8, 2021 Author Share Posted March 8, 2021 Okay, I have RMA'd the motherboard (only new component) and also realised I wanted more capability and have previously run unraid on an x570 board without issue before, will arrive tomorrow or day after, when it arrives I will run in Safe mode overnight. Something else to mention, before moving, it was running on Intel hardware. While I wait for the new Ryzen board I have switched back with no issues since. I have seen that moving between hardware upgrades is "plug and play" which it essentially was, but not seen someone switch between Intel and AMD hardware Quote Link to comment
Hankanman Posted March 10, 2021 Author Share Posted March 10, 2021 Hey, attached is the diagnostics after putting the new x570 board in, and booting in safe mode, now running in normal mode (with a lot of plugins uninstalled), looking good so far endeavor-diagnostics-20210310-1435.zip Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.