Hi

esata tower for 5 disks. 4 other HDDs visible (2t/2tb/250gb/750gb) and this one not.

System - QNAP TS-459 with Unraid newest version. 4 drives built in and 5 drives with esata tower.

Used this hardware config for few years and with original QNAP software it worked without any issues and this disk was visible.

I even booted now with QNAP - all good. Only unraid does not see it?

Any ideas why? How I can try to check logs for what is going on?

Edited March 25, 20215 yr by Nicodem

Please post the diagnostics: Tools -> Diagnostics

So it seems that its not hot-swap in my configuration. I restarted Unraid and at same time of boot started whole esata array and now its visible.

nas-459-diagnostics-20210325-1739.zip

 

 

So it's working now? Also note that SATA port multipliers are not recommended with Unraid, you may run into more issues in the future.

Now yes. This SATA multiplier worked for me OK for years at QNAP so this should be OK. Anyway - only NTFS mounted there.

Array will be built at the internal 4 drives.