March 26, 20215 yr My recent Unraid server build failed the same as this, I then wiped the USB and installed from scratch and then re-installed all apps, shares and VM was there still and within 15 minutes I was back up running. I purchased an upgrade from plus to pro due to a partial error on my behalf, added the extra 8 drives and restarted and now I can ssh, ping the server but I can't access the Web GUI again. I have changed the port from 80 to 80008 but no joy still, attached the diagnostic zip to see if you folks can assist. I did add the device as a static IP from the router, the router alos shows the right IP, I can ping the UP and the DNS name. Look forward to some suggestions. There maybe a bigger back story which may help but a long write up..... proliant-diagnostics-20210326-1852.zip
March 26, 20215 yr Author Just thought that it gone after each time i installed the 'My Servers' plugin
April 7, 20215 yr I am having the same issue.. my WebGUI is gone after installing the My servers plugin
April 7, 20215 yr Community Expert Do you mean you can't get the webUI to appear on a monitor attached to the server when you boot in GUI mode? Or do you mean you can't access the webUI from another computer on your LAN? Have you tried accessing it by IP address?
April 7, 20215 yr Author via another PC, I could Ping the IP, local server attached monitor and could use the local screen etc. I ended up scrubbing the USB and installing again, recording each stage, soon as My Server was installed and then restarted same issue happened here are my steps recorded Proliant new instal 6.9.1 @ 18:45 installed new key restart all OK added the standard disks restart all OK - rebuilding disks all disk in restarted - OK - formatting 8/9 Formstting all disk now then reboot apps installed * CA Fix common added notify for updates OK Installed Binhex Krusdaer restartOK Preclear, Fix common, unaasigned restart OK VM - w2k16 restart OK VM server install local apps OK MY Server restart Lost web GUI! Wipe drive and restart
April 9, 20215 yr Are you saying that simply installing the plugin causes problems? Or does it happen when you enable local SSL? If there is a problem enabling local SSL it is likely a conflict on port 443. Go to Settings -> Management Access and set HTTPS port to something that is not in use by one of your apps, perhaps 2443, 3443, 4443, etc.
Archived
This topic is now archived and is closed to further replies.