10gb card only showing 1000mb speed


Recommended Posts

Are you sure that you are on one of the 2 10Gb ports of the switch ?

from ethtool it seems eth9 is 10Gb compatible but the partner is not.

 

Settings for eth9:
	Supported ports: [ TP ]
	Supported link modes:   100baseT/Half 100baseT/Full
	                        1000baseT/Full
	                        10000baseT/Full
	Supported pause frame use: Symmetric Receive-only
	Supports auto-negotiation: Yes
	Supported FEC modes: Not reported
	Advertised link modes:  100baseT/Half 100baseT/Full
	                        1000baseT/Full
	                        10000baseT/Full
	Advertised pause frame use: Symmetric Receive-only
	Advertised auto-negotiation: Yes
	Advertised FEC modes: Not reported
	Link partner advertised link modes:  100baseT/Full
	                                     1000baseT/Half 1000baseT/Full
	Link partner advertised pause frame use: Symmetric Receive-only
	Link partner advertised auto-negotiation: Yes
	Link partner advertised FEC modes: Not reported
	Speed: 1000Mb/s
	Duplex: Full
	Auto-negotiation: on
	Port: Twisted Pair
	PHYAD: 17
	Transceiver: internal
	MDI-X: Unknown
	Supports Wake-on: g
	Wake-on: d
        Current message level: 0x00000000 (0)
                              
	Link detected: yes

driver: bnx2x
version: 5.10.28-Unraid
firmware-version: FFV7.4.8 bc 7.4.19 phy 1.34
expansion-rom-version: 
bus-info: 0000:07:00.1
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes

 

But I am super bad at network stuff so I might be wrong. :D 

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.