Very slow performance when using Rclone on Windows to download from GDrive to unraid share (P:)

[Jinxyface]

Hello guys, new to Unraid. I was using a Synology DS1019+ but decided to make my own NAS for freedom to upgrade and whatnot. I was using Rclone/RcloneBrowser on my Windows machine to sync up my Synology NAS (P: drive) to my mounted GDrive (X: drive).

 

When uploading from Synology to GDrive (P: -> X:) I would get about 120MB/s

When downloading from GDrive to Synology (X: -> P:), I would also get the same speed

 

The Synology is decommissioned now and my unraid box is working (ver 6.9.2). I've create the array for my drives, created a user share, and mounted unRAID to the same letter as my old Synology (So P:)

 

But now when I download from GDrive to unRAID (X: -> new P:) I'm getting around 30MB/s. I have 5 drives all connected through a SAS2 LSI-9211-8i card. And this is only happening when it's X: -> P: through Rclone

 

If i download from Rclone to my local storage drive (E:) I get full speed, and then if I drag and drop the files from Windows to the unRAID (local E: to unRAID mount P:) share, it's full speed. It only seems to be when I remove the middle-man that is Windows that the spee drops off. Does anyone have any ideas?

 

I'm new to unRAID so I don't know if there's some special settings I need to check. Should I set up Rclone on unRAID directly? For notes, I have no parity or cache drives right now (once everything is on the unraid box I will add a parity drive next), so everything is directly on the drives behind no parity or cache at the moment, as everything is in GDrive also.

Edited April 27, 2021 by Jinxyface