May 11, 20215 yr Hello, I recently bought a new disk for my array, i shucked it from a Seagate Expansion (ST10000DM0004). I took out and old disk, replaced and started the rebuilding process. It was going well until the 80% mark, when it starting to through errors (UDMA CRC). The process stopped and a parity sync started. I now have 512 errors on the disk array, and everything paused. What steps should I take? ivpiter-syslog-20210511-0730.zip
May 11, 20215 yr Community Expert Syslog is spammed with other issues, can't see the disks errors, but disk itself looks fine, and the high number of UDMA CRC errors suggest a bad connection, replace SATA cable/slot and try again.
May 11, 20215 yr Author I had it connected to a HBA card, I replaced it with a SATA cable to the mobo to see how it goes. However now the array started but the disk is still disabled. The only option is to do a parity check. Should I do a full check and then take the disk out to redo the rebuilding process? Thanks for you help!
May 11, 20215 yr Community Expert Unassign the disk, start/stop array, re-assign the disk to begin another rebuild.
Archived
This topic is now archived and is closed to further replies.