I have purchased a Dual NIC and installed it in my unRAID device, however it does not appear to be detecting it and allowing me to use it.

 

I have tried reseating the NIC and moving it to another slot on the Motherboard but no luck. I did install it in another PC as a test and that uses Windows, and it detected it fine.

 

This is the NIC I am using;

https://www.amazon.co.uk/gp/product/B07Y1P4DGV

 

I can't see anything obvious in the logs, and can see my onboard NIC shows up fine, but could well be missing something.

 

Any help / advice is greatly appreciated.

 

Thanks!

tower-diagnostics-20210529-2207.zip

Card doesn't seem to be in lspci, which motherboard slot is it in, have you confirmed slot is avaiilable if nvme etc are conmected.

3 minutes ago, SimonF said:

Card doesn't seem to be in lspci, which motherboard slot is it in, have you confirmed slot is avaiilable if nvme etc are conmected.

Thanks for having a look. Its currently in PCIEX1_1 and has also been tested in PCIEX1_2. 
I did have a USB Expansion Card in that slot before, and any devices connected always seems to show as expected, so it should be working.

PCIEX16_3 Control
[Auto] If PCIEX16_3 is detected, run X4 mode and disable PCIEX1_1 + 
PCIEX1_2 + PCIEX1_3, otherwise enable PCIEX1_1 + PCIEX1_2 + 
PCIEX1_3.
[X1 mode] PCIEX16_3 runs X1 mode and enable PCIEX1_1 + PCIEX1_2 + 
PCIEX1_3.
[X4 mode] PCIEX16_3 runs X4 mode and disable PCIEX1_1 + PCIEX1_2 + 
PCIEX1_3.

 

@timethrowDo you have any thing in 16_3 
 

Edited May 29, 20215 yr by SimonF